Big Baby is a 150mm X8 for 3″ props. It has a 4mm base plate and a 2mm top plate. The motors are stacked using low profile 2mm catdog mounts. Stack height is 25mm (leave me a note if you’d like 30 or 40mm instead), which fits 2 4in1’s and the fc. The Lumenier Lux7 is recommended for X8’s. The frame is drilled for 2 30×30 and 20×20 stacks.

This frame is not recommended for beginners as has limited instructions and can be quite tricky to install electronics inside the low profile frame.

The fpv cam mount and antenna mounts wedge in the DJI air unit.

Andy Shen uses 8x 1407 2800kv motors powered by a 850mah 6s Lipo.

You can print the parts yourself, files are here . If you’d like me to print the parts they can be red, orange, blue, or clear. Leave a note if you have a preference.

I’m calling this a beta ’cause I’m not sure why this little guy needs to exist, other than fun, or a tiny cine platform that can be as fast as a 5″. The frame design is pretty solid and I don’t anticipate it changing much.

This frame is sold with optional 3D printed parts

• 3D printed parts are available here