Pinbetween gives you access to all of the micro: bit’s pins at the same time as using an edge-connector add-on, and it’s completely solderless!

The 40-pin male header on Pinbetween lets you use jumper jerky to connect extra bits to your micro: bit while using an edge-connector add-on like the enviro: bit, for example.

Plug your micro: bit into the edge connector at the top, attach your micro: bit add-on at the bottom, and then use the handily grouped and labeled pins in between for whatever you wish!

Note: micro: bit, enviro: bit, breadboard, etc. pictured are not included!

Features

• Comes fully-assembled and ready to use
• The 40-pin male header is for use with jumper jerky
• Grouped and labeled pins
• Plenty of power pins (9x 3V, 12x ground)
• Male edge connector for micro: bit add-ons
• Compatible with micro: bit and micro: bit v2
• No soldering is required!
• Dimensions: 56×41.5x12mm