sku: DEV-10570

The Danger Shield mounts on top of your Arduino r Arduino Pro and equips it with a variety of fun and useful inputs and outputs. The Danger Shield has so much potential; we can’t wait to see what you’re able to do with it! The shield’s features include:

• Three linear slide potentiometers connected to the Arduino’s analog pins 0 through 2.
• Red and yellow LEDs connected to digital pins 5 and 6 – PWM pins – so you can easily vary their brightness.
• Three momentary push buttons connected up to the Arduino’s digital pins 10 through 12. Those lines will go low when the buttons are pressed.
• A photocell and a temperature sensor, both with analog outputs, are connected to the analog pins 3 and 4, respectively.
• An 8-bit shift register set up to control a blue 7-segment LED.
• Two buzzers – one is used, as you’d expect, as a speaker, the other is connected to analog pin 5 and can be used as a knock sensor.
• Capacitive Touch pad – Using the CapSense library to sense touch.

This product comes as a kit of parts, which you’ll have to solder into the included PCB. All parts are through-hole so it should go together relatively easily; but always check your component orientation before soldering!

Kit Includes

• 1x PCB Danger Shield Kit
• 3x Slide Potentiometers – 10K
• 1x 7-Segment LED – Blue
• 1x 8-bit Shift Register – 74HC595
• 1x Temperature Sensor – LM335A
• 1x Miniature Photocell
• 1x Buzzers
• 1x Basic LED – Red
• 2x Basic LEDs – Yellow
• 1x Mini Push Button
• 3x Momentary Push Buttons – 12mm Square
• 11x Resistors – 330 Ohm
• 4x Resistors – 10K Ohm
• 1x Resistor 1M Ohm 1/6W
• 2x 8-pin Arduino Stackable Headers
• 2x 6-pin Arduino Stackable Headers

Documents

• Schematic
• Eagle Files
• Example Code