This is a combo pack of the incredible Pixhawk 2.1 (the cube) autopilot along with the all new Here v2 GNSS module which raises the bar for commercial navigation solutions.

The pixhawk 2.1 is the latest and greatest platform for the ardupilot project. Designed to be developer friendly, easy to use and incredibly reliable, the pixhawk 2 is the ideal system to use for your next drone project, be it commercial, research or hobbyist. The pixhawk 2 is designed to be a fully integrated single board flight controller with sufficient I/O for the most demanding of applications. In addition the sensor performance and reliability has greatly been improved, with triple redundant IMU’s, and the capability to use up to 3 GPS modules. Through smart design the bill of materials has been reduced which keeps the overall design simple, affordable and extremely light at only 75 grams per board.

Whats included

• Pixhawk 2.1 Autopilot Kit (Aka The Cube)
• Here v2 GNSS module
• Connector cable pack
• Power module

Key Features (The Cube)

• Triple redundant vibration damped IMU with support for up to 3 GPS modules
• All in one design with integrated FMU
• Heating system to fly in very low temperatures
• Lots of I/O ports (see below for full list)
• Sepaerable carrier board to allow developers to build and use their own
• Onboard battery backup for FMU and IO SRAM/RTC
• Separate power supplies for FMU and IO

Key Features (Here v2)

• Built in STM32F302 MCU running ChibiOS to enable user defined features and easy firmware updates
• Adds 10DOF IMU sensor (ability to run its own EKF solution onboard the GPS module)
• CANBUS support