The WisMesh Base Board RAK19026 is the ideal entry point for exploring and using the Meshtastic LoRa Mesh Network.

• Includes nRF52840 RAK4630 LoRa module, pre-flashed with Meshtastic firmware

• Integrated 1.3 OLED display

• Onboard GNSS location module (u-blox ZOE-M8Q)

• Onboard motion sensor (ST LIS3DH)

• Expansion slots: two WisBlock Sensor slots and one WisBlock IO module slot

• Integrated user-programmable button

• On/off switch disconnects battery completely from electronics while allowing charging via USB or solar battery

Quick Setup

• Ready for use in a short time with the Meshtastic Getting Started Guide

Key Features

• RAK4630 WisDuo module, pre-flashed with the Meshtastic firmware
  • Nordic nRF52840:
    • Ultra-low-power MCU
    • 32-bit ARM Cortex-M4F CPU
    • 64MHz CPU clock
    • 1 MB Flash, 256 KB RAM
  • Semtech SX1262:
    • Low power high range
    • LoRa transceiver
• 2 sensor slots
• 1 IO slot
• Battery switch
• User button
• Connector for OLED display
• GPIO exposure on pin header
• 1.3 OLED display (pre-mounted or optional connected through a pin header)
• U-Blox ZOE-M8Q GNSS location module onboard
• ST LIS3DH motion sensor onboard
• LoRa and BLE antenna included

Package Inclusions

• 1 pc RAK19026 WisMesh BaseBoard
• 1 pc OLED display (optional)
• 1 pc LoRa antenna
• 1 pc BLE antenna
• 1 pc GPS antenna
• 1 pc USB cable

Documentation

• WisMesh Base Board RAK19026 Quick Start Guide
• WisMesh Base Board RAK19026Datasheet VA
• WisMesh Base Board RAK19026Datasheet VC
• WisMesh Base Board RAK19026 3D file without OLED
• WisMesh Base Board RAK19026 3D file with OLED
• RAK19026 w/o OLED 3D Model
• RAK19026 w/ OLED 3D Model