Place your Raspberry Pi camera up to 15 metres away with the Arducam LAN Cable Extension Kit. It converts the MIPI CSI-2 interface to Ethernet, works out of the box with Pi 5/4/3/CM, and supports a wide range of cameras.

The Arducam LAN Cable Extension Kit lets you place your Raspberry Pi camera up to 1015 metres away from your board using a standard LAN cable (1m cable included). It converts the high-speed MIPI CSI-2 interface into an Ethernet-compatible connection, allowing far greater range than a traditional FFC cable – and without needing any additional software or configuration.

Its plug-and-play with Raspberry Pi 5, 4 and 3 and Compute Modules (CM modules via carrier boards with appropriate IO available). Simply connect your camera and board at each end of the LAN cable, and youre ready to go. A 1m Rj45 cable is included to get you started, but you’ll find longer RJ45 cable options in the store.

The kit supports a wide range of camera modules, including:

• Official Raspberry Pi Camera Modules
• Arducam camera modules
  • OV5647, IMX219, IMX296, IMX477, IMX708
  • 16MP, 64MP Hawkeye, 64MP Owlsight
  • ToF cameras

Raspberry Pi and camera modules not included

Supported Camera and Modes

Resources

• Arducam Wiki entry
• 3D drawing for U6248

Package Contents

• 1x Rx board
• 1x Tx board
• 1x 1m LAN cable
• 2x 8cm ribbon flex cables for MIPI CSI-2 Transmission
• 2x 7.3cm 15-22pin FPC Cable
• 1x Mounting screw pack

Raspberry Pi and camera modules not included