Waveshare 1.3inch 240×240 IPS SPI LCD Module

Waveshare 1.3inch LCD Module is a compact IPS display module with a 240×240 HD resolution panel and SPI communication. It is designed for embedded display projects that need a small square screen with clear color output, simple wiring, and broad controller compatibility.

The module integrates an ST7789 display driver, supports RGB 65K color, and works with 3.3V or 5V operating voltage. The SPI interface helps reduce GPIO usage, while the LED backlight and IPS panel make it suitable for dashboards, device interfaces, status monitors, and compact control panels.

For related Waveshare display options, compare the Waveshare 0.96inch LCD Module, Waveshare 0.85inch LCD Module, and Waveshare 1.3inch LCD for Raspberry Pi Pico. For a larger square touch option, see the Waveshare 1.54inch Touch LCD Module.

Technical Specifications

Interface Notes & Hardware Guidance

• SPI wiring: Connect DIN and CLK to the controller SPI data and clock lines, then assign CS, DC, RST, and BL according to your firmware configuration.
• Voltage planning: The module supports 3.3V and 5V operation, but the connected controller and signal wiring should still be checked for logic-level compatibility.
• Driver support: Use ST7789-compatible display libraries or Waveshare reference examples when integrating with Raspberry Pi, Arduino, STM32, or similar controllers.
• Backlight control: The BL pin can be used for backlight enable or brightness-control workflows depending on the host board and software setup.
• Mechanical layout: Confirm the module dimensions and mounting clearance against your enclosure or panel before final assembly.

Packing List

FAQ

What display driver does this module use?

It uses the ST7789 display driver, so choose software libraries or examples that support ST7789 SPI LCD panels.

What resolution does the display provide?

The module provides a 240 x 240 square resolution on a 1.3inch IPS LCD panel.

Does it use SPI communication?

Yes. The module communicates through SPI and uses control pins including CS, DC, RST, and BL.

Can it work with both 3.3V and 5V systems?

The official operating-voltage reference is 3.3V / 5V, but users should still verify host-board logic levels and wiring before integration.

Are development examples available?

Yes. Waveshare provides development resources and manual references for Raspberry Pi, Arduino, and STM32 workflows.